Three unique advantages of aluminum radiators:

1. Aluminum profile radiators have good heat dissipation and obvious energy-saving characteristics. In the same room, if radiators of the same specification are used, the number of aluminum cast sheets is less than that of steel.

2. The aluminum profile radiator has good oxidation and corrosion resistance without adding any additives. Its principle is that once aluminum encounters oxygen in the air, it forms a layer of oxide film, which is both tough and dense, preventing further corrosion of the body material.

3. Choose an aluminum profile radiator, preferably a combination of high-pressure cast aluminum modules. This type of radiator is formed by one complete die casting, so there is no problem of weld leakage. Moreover, its biggest advantage of aluminum radiators is that the product is not limited by residential heating systems, and even in open boiler systems, it can be free from oxygen corrosion. Due to the use of modular aluminum radiator design, if the indoor temperature is not enough after a heating season, one or two more can be installed the next year to meet their needs, without the need to replace the entire set of heating like steel radiators.

At present, aluminum profile heat sinks are mainly used in devices such as televisions, audio amplifiers, automotive circuit boards, computer CPUs, graphics cards, etc. What is the specific installation process? Let's take a look together!

Firstly, please open the packaging of the aluminum radiator and install the vent valve and union.

2. The position of the hole for installing the special hook can be marked on the wall according to the provided installation diagram or relevant requirements

3. When installing aluminum profile radiators, it is necessary to consider the damage caused by thermal expansion and contraction of the heating pipes to the radiators.

4. Place the 12 expansion pipes in and flat.

5. Please use an impact drill to drill 12 holes, with a depth that is suitable when the expansion pipe is inserted and its outer edge is flush with the wall.

6. Install the bottom hook and tighten the screws after meeting the requirements.

7. Place the aluminum profile radiator on the installed hook at the bottom, adjust the position of the hook by installing the upper hook, and tighten the expansion screw only after it is tightened. When placing the radiator, place the vent valve above.

8. After installing and assembling the pipeline joints, install the pipelines according to the drawing requirements and connect them to the inlet and outlet. Tighten all parts, with the rear side 3.5cm away from the wall and 5cm away from the skirting line.

9. Please input hot water, open the vent valve, and vent until water flows out. The aluminum profile radiator should not exceed the working pressure listed in the manual by 0.12Mpa during operation

10. The oxygen content in the heating medium shall not exceed 0.05g per square meter. The medium used for radiators should be water with a pH of 9 ≤ 9, and with internal anti-corrosion measures, pH ≤ 12